Description
Key Features
- Ideal for wooden or metal 5 bar style gates
- Residential use only
- Easy and quick installation
- Inward/Outward opening
- Simple wiring & programming
- Wider opening angles possible up to 110° depending on the gate/hinge configuration
Product Overview
The myAster packs a lot of power for its price, offering incredible value for money.
MyAster Swing Gate Actuator offers convenience and reliability in a compact, aesthetic design.
Complete access solution for any existing or brand new property, residential and apartment complexes. This locked electromechanical actuator is entirely aluminium casted mounting a telescopic stainless steel pipe, that grants durability over time and under any weather conditions. Practical release system for manual operation in case of power-cut. Screw-driven action and multi-position fixing brackets, this actuator mounts directly to your gate and pillar, which simplifies installation and does not require concrete mounting pads. MyAster is controlled by a control board featuring: obstacle detection, simplified self-learning programming mode, adjustable settings of working times and force, delay time, pedestrian opening and slowdown.
Available in 230V and 24V.
Limited Warranty - 3 years on motors, 1 year on other components.
Kit Suitability
The myAster has linear ram (straight arm) motors which mount on brackets (highlighted in yellow below) attached to the pillars.
For optimum leverage and mechanical advantage the motors should be mounted where the A & B measurements are equal as per table below.
Recommended Installation (90° opening)
A + B = C (motor Stroke)
A |
B |
C |
|
myAster 3TI |
150mm | 150mm | 300mm |
myAster 4TI |
200mm | 200mm | 400mm |
myAster 5TI |
250mm | 250mm | 500mm |
myAster 6TI |
300mm | 300mm | 600mm |
If the ideal scenario of A & B is not achievable, refer to the below table to determine bracket position. (mm)
The D dimension only comes into play when the gate is side hung.
myAster 3TI max D measurement = 125mm
myAster 4TI max D measurement = 175mm
myAster 5TI max D measurement = 225mm
myAster 6TI max D measurement = 275mm
Before purchasing this kit it is important to note the width of your post/pillar and hinge position.
Your post/pillar must be wide enough to fix the bracket so the A & B measurements can be achieved for the motor you require.
Installation Advice
When fitting the gate brackets to a wooden gate, we recommend that you insert stainless steel tubing (just large enough to sleeve the mounting bolt threads and 1mm shorter than the thickness of the wood) through the gate mounting holes. This will prevent over-tightening of the mounting bolts and also avoid the repetitive push/pull on the mounting bolts from damaging the wood - See the instruction manual under the download section on this page for more information.
Gate Stops
These electric gate motors require a physical stop at the end of the opening and closing cycle. Gate Stops provide resistance to the motors so they know they've reached either the open or closed position. Without gate stops the motors will over extend during their operation and the mechanism will eventually fail. When assessing your gate-way it is important to check you can install physical stops in both the closing and opening positions. Common reason's why gate stops cannot be installed are a sloping driveway or the gate is raised significanlty off the ground. If you cannot install something to provide resistance at either end of the motors cycle then you will require a specialised ram with in-built mechanical stops.
